IX-LAT-500 CNC Turning Lathe Specifications, Operation & Selection Guide

The values below come from the supplied 2026 IXORTA catalogue. Use them to build an initial shortlist, then confirm the exact configuration, options and acceptance criteria in the model-specific quotation.

Before ordering: confirm the duty, usable capacity, overall dimensions, utilities, safety package, controls, attachments and documentation for the destination market. Download the division catalogue.

IX-LAT-500 sits between the smaller and larger configurations in this 4-model range, making side-by-side specification comparison especially important.

Shortlist this model when the planned duty is close to its listed values. If the application regularly approaches a limit, compare the adjacent models below and ask IXORTA to check working margin, cycle expectations and future capacity.

Compare every cnc turning lathes model.

After secure chucking and tool setup, the operator establishes offsets, proves the program and verifies clearance. The spindle rotates the work while servo axes position the turret; coolant, chip control and measured inspection support repeatable production.

The safe sequence depends on the supplied guards, controls, utilities and attachments. Operators should follow the delivered manual, training and site risk assessment. For process examples and planning articles, continue to the IXORTA CNC industry guides.

Manufacturing and acceptance checks should verify bed rigidity, spindle alignment, chuck operation, turret indexing, axis backlash, guarding, lubrication, coolant flow and a representative trial part.

A useful factory-acceptance record identifies the agreed configuration, principal components, inspection points, test material or load, observed results, open actions, documentation set, packing method and release approval. See IXORTA CNC project scopes for the wider delivery context.

A catalogue capacity alone is not enough. IXORTA should receive the normal and peak operating range, site conditions, utilities, operator experience, destination and delivery constraints before recommending a configuration. Review the division buyer FAQs before sending the enquiry.

1. Define the job. Record material, load, output, quality and environmental requirements.
2. Inspect before start. Check guards, fluids, fasteners, tooling or attachments, connections and the work area.
3. Set the equipment. Apply the model manual, verified program or calibrated field setting.
4. Prove at low risk. Run a dry cycle, first part, clean-water test or short field pass as appropriate.
5. Monitor production. Watch load, sound, temperature, quality, flow, alignment and safety devices.
6. Close and record. Isolate safely, clean, inspect wear and log service actions.

Use the project enquiry form to identify any required training, commissioning or operator documentation.

• clean the chuck and inspect jaws
• monitor way lubrication and hydraulic level
• remove chips from conveyors and guards
• inspect tool holders and verify offsets

Intervals depend on operating hours, duty, dust, heat, water quality and the surrounding environment. The delivered manual and component schedules control the final service plan. Send spare-parts and service questions through the IXORTA contact page.

Confirm workpiece material and size, output target, electrical supply, ambient factory temperature, controller preference, tooling, extraction or coolant duties, operator skills, destination port and inland delivery route.

For a useful export quotation, include the destination port, inland route, unloading equipment, site access, local standards, document language, commissioning responsibility and critical spare-parts expectation. Browse regional project examples.